How to Mix Vocals in FL Studio
Transform raw recordings into professional-sounding vocals. Use EQ, Compression, and De-essing to make your voice sit perfectly.
This guide walks you through the essential signal chain for mixing vocals in FL Studio. You will learn how to balance dynamics and frequency for a clear, modern sound.
Follow these steps
Clean the Low End
Use Fruity Parametric EQ 2 to cut everything below 100Hz. This removes low-end rumble and 'thumps' from the microphone.
Balance the Dynamics
Add 'Fruity Limiter' in Comp mode. Adjust the Threshold until you see 3-6dB of gain reduction on the peaks to even out the volume.
Enhance Presence with EQ
Apply a gentle boost around 3kHz to 5kHz for clarity. If the vocal sounds 'muddy,' make a small cut around 300Hz.
Add Depth with Reverb
Send your vocal to a Reverb track (as learned in the Sends tutorial). Blending in just a little reverb adds depth and professional polish.
Common mistakes
- Over-compressing the vocal, which makes it sound flat and lifeless.
- Boosting high frequencies too much, leading to harsh 'S' and 'T' sounds.